Electric Power Generation

C18 (50 Hz)

Producing reliable power from 455 kVA to 600 kVA at 50 Hz, our C18 diesel generator sets are made to meet your standby and prime applications. Each is designed to ISO 8528-5 transient response requirements and built accept 100 percent rated load in one step. Our C18 generator sets range from low fuel consumption systems to EPA Stationary Emergency (Tier 2) certified. Seismic certification is also available for select models, so you can deliver power despite disturbances. Our integrated control system, including ATS and switchgear ensure a consistent power supply and connection to your fleet through on-site and remote monitoring options. We offer a wide range of EMCP 4 control panel options, with a simple screen display, consolidating all your management and diagnostics tools. The EMCP 4.4 controller provides on package paralleling capability, allowing you to use multiple generator sets to power your facility, providing added capacity and redundancy. We've made our generator sets adaptable to your demands with a broad range of accessories and bolt-on system expansion attachments. Find flexible packaging to fit your spatial restrictions and environmental conditions. Even choose UL 2200 and CSA certified package options for added safety.

Overview

Producing reliable power from 455 kVA to 600 kVA at 50 Hz, our C18 diesel generator sets are made to meet your standby and prime applications. Each is designed to ISO 8528-5 transient response requirements and built accept 100 percent rated load in one step. Our C18 generator sets range from low fuel consumption systems to EPA Stationary Emergency (Tier 2) certified. Seismic certification is also available for select models, so you can deliver power despite disturbances. Our integrated control system, including ATS and switchgear ensure a consistent power supply and connection to your fleet through on-site and remote monitoring options. We offer a wide range of EMCP 4 control panel options, with a simple screen display, consolidating all your management and diagnostics tools. The EMCP 4.4 controller provides on package paralleling capability, allowing you to use multiple generator sets to power your facility, providing added capacity and redundancy. We've made our generator sets adaptable to your demands with a broad range of accessories and bolt-on system expansion attachments. Find flexible packaging to fit your spatial restrictions and environmental conditions. Even choose UL 2200 and CSA certified package options for added safety.

Generator Set Specifications

Minimum Rating550 kVA
Maximum Rating715 kVA
Voltage208 to 600 Volts
Frequency50 Hz
Speed1500 or 1800 RPM

Generator Set Configurations

Emissions/Fuel StrategyLow Fuel Consumption, U.S. EPA Certified for Stationary Emergency Use Only (Tier 2 Nonroad Equivalent Emission Standards), China Nonroad III Emission Standards

Engine Specifications

Engine ModelC18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Bore145 mm (5.71 in)
Displacement18.13 L (1106.36 in3)
Stroke183 mm (7.2 in)
Compression Ratio14.5:1
AspirationAir to Air Aftercooled
Governor TypeAdem™A4
Fuel SystemElectronic unit injection

Air Inlet

  • Air Cleaner

Cooling

  • Package mounted radiator

Exhaust

  • Exhaust flange outlet

Fuel

  • Primary fuel filter with integral water separator
  • Secondary fuel filter
  • Fuel priming pump

Generator

  • Matched to the performance and output characteristics of Cat engines
  • Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
  • IP23 Protection

Power Termination

  • Bus Bar

Control Panel

  • EMCP 4 Genset Controller

Mounting

  • Rubber vibration isolators

Starting/Charging

  • 24 volt starting motor
  • Batteries

General

  • Paint - Caterpillar Yellow except rails and radiators gloss black

Back to this category

Back
to top